Rebooting the System
Run the command:
admin@localhost:$ sudo reboot
Returns:
System reboot successfully
Root user credential
Run the command:
admin@localhost:$ sudo su -
Returns:
$ admin@localhost:~# sudo su –
$ root@localhost:~#
Identifying the System Service Tag
Run the command:
admin@localhost:$ cat /sys/class/dmi/id/product_serial
The system tag is printed.
Powering off the system
Run the command:
admin@localhost:$ sudo poweroff
The system shuts down successfully.
Network communication interfaces
The Edge Gateway 3000 series comes with an Ethernet connection, 802.11b/g/n wireless network connection, and Bluetooth network
connection.
Ethernet (Port 1, eth0)
Assuming that you have an internet-enabled Ethernet cable plugged into Port1, your screen should be similar to the one below after
running the
ifconfig
command. If the WLAN and Bluetooth are not configured, they are not displayed in the network device list.
admin@localhost:~$ ifconfig
After running the
ifconfig
command:u
eth0 Link encap:Ethernet HWaddr 74:e6:e2:e3:0f:12
inet addr:192.168.28.216 Bcast:192.168.28.255 Mask:255.255.255.0
inet6 addr: fe80::76e6:e2ff:fee3:f12/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:11 errors:0 dropped:0 overruns:0 frame:0
TX packets:19 errors:0 dropped:0 overruns:0 carrier:0
Collisions:0 txqueuelen:1000
RX bytes:1740 (1.7 KB) TX bytes:2004 (3.0 KB)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:65536 Metric:1
RX packets:160 errors:0 dropped:0 overruns:0 frame:0
TX packets:160 errors:0 dropped:0 overruns:0 carrier:0
Collisions:0 txqueuelen:1000
RX bytes:13920 (13.9 KB) TX bytes:13920 (13.9 KB)
admin@localhost:~$
WLAN (wlan0)
Use these identifiers in the following examples:
51