Dell DSS 2500, Руководство пользователя

Страница: 101 / 163

3 internal PERC riser 4 PCIe connector on internal PERC riser card
5 release tab 6 locking notch on the expansion card
Next steps
1 Follow the procedure listed in the After working inside your system section.
2 Install the internal PERC riser on the system board.
3 Install the cooling shroud.
4 If removed, reinstall the dual riser module.
NOTE: If required, open the expansion card latch on the cooling shroud to support the full length card.
5 Reconnect the disconnected cables to the expansion card(s).
Related links
Safety instructions
Before working inside your system
Removing the dual riser module (optional)
Removing the cooling shroud
Removing the internal PERC riser
Installing an expansion card into the internal PERC riser
Installing the internal PERC riser
Installing the cooling shroud
Installing the dual riser module (optional)
After working inside your system
Installing an expansion card into the internal PERC riser
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 If connected, disconnect the cables from expansion card (s).
4 If required, remove the dual riser module.
NOTE: If open, close the expansion card latch on the cooling shroud to release the full length card.
5 Remove the cooling shroud.
6 If installed, remove the internal PERC riser
Steps
1 Locate the expansion card connector on the internal PERC riser.
2 Holding the card by its edges, position the card so that the card’s edge connector aligns with the internal PERC expansion card
connector.
3 Align the slot on the internal PERC riser with the expansion card.
4 Slide the expansion card into the internal riser connector until the card is fully seated and the blue release tab clicks into place.
5 If applicable, connect cables to the expansion card.
6 Install the expansion card riser on the system board.
Installing and removing system components 101