Installing the 2.5–inch hard drive into the drive bracket
1. Align the hard drive to the side of the hard drive bracket, and pull the other end tabs to insert the pins on the bracket into
the hard drive.
2. Insert the hard drive into the hard drive bracket and press the hard drive until it clicks into place.
3. Install the:
a.
b.
c.
After working inside your computer
.
Optical drive
Removing optical drive
Before working inside your computer
.
2. Remove the:
a.
b.
3. Open the
.
4. To remove the optical drive assembly:
a. Disconnect the data cable and power cable from the connectors on the optical drive [1].
NOTE:
Ensure to unroute the cables from the tabs under the drive cage to allow you to disconnect the cables from
the connectors.
b. Close the front panel door [2].
22
Disassembly and reassembly
Содержание D18M
Страница 1: ...OptiPlex XE3 Tower Service Manual Regulatory Model D18M Regulatory Type D18M005 August 2021 Rev A01 ...
Страница 23: ...c Press the blue release tab 1 and slide the optical drive out of the computer 2 Disassembly and reassembly 23 ...
Страница 43: ...5 Pull the power switch out from the computer Disassembly and reassembly 43 ...
Страница 60: ...b Slide and lift the system board away from the computer 1 2 60 Disassembly and reassembly ...