Dell C300, Установка

Страница: 56 / 76

56 | System Boot
www.dell.com | support.dell.com
To configure the chassis from the BOOT_USER prompt, use the following commands:
Command
Purpose
help
or
?
• Enter
help
or
?
to display a list of available commands and syntax.
• Enter
syntax help
t display syntax information and variable descriptions.
boot change
{
primary
|
secondary
|
default
}
If your configuration displays no pre-configured operating system boot
parameters, use the
boot change
command to edit appropriate fields.
• The
primary
operating system boot parameters are used in the first attempt
to boot the system.
• The
secondary
operating system boot parameters are used if the primary
operating system boot selection is not available.
• The
default
operating system boot parameters are used if the secondary
operating system boot parameter is not available. The default parameters
always reside on the internal flash drive (flash).
NOTE:
These parameters, as well as other boot parameters, can be
modified in run-time mode
When you enter the boot change command, you are prompted for a response.
• Enter a new parameter or press the ENTER key (carriage return) to accept
the default parameter.
• Enter . (period) to clear a field.
• Enter - (dash) to edit a field above the current cursor position.
NOTE: When you enter a new parameter that extends beyond 80
characters, you cannot use the BACKSPACE key to correct any mistakes. If
you make a mistake, you must re-enter the parameter.
show bootvar
This command displays the current operating system boot configuration
parameters
show bootflash
This command displays information about the current boot ROM.
interface management port config
100m
interface management port config
10m
interface management port config
auto-negotiate
interface management port config
no auto-negotiate
interface management port config
full-duplex
interface management port config
half-duplex
interface management port config
show
• Use these commands to set the speed and duplex settings for the
Management interface. The default setting is full-duplex and auto-
negotiation.
• Use the
interface management port config show
command to view
the management interface’s physical settings.