Dell C300, Установка

Страница: 37 / 76

Installing DC Power Entry Modules | 37
Step Task (continued)
4
Slide the PEM into slot 0 or 7 (see (Figure 8-2) . If you are installing redundant PEMs, install in both slots 0 and 7.
NOTE:
Fill all empty slots with blank panels.
Figure 8-2. Insert 2 DC PEMs in Slots 0 and 7
5
Secure the PEM in place by tightening the retaining latch on each module so that the arrow points down
(Figure 8-2) .
6
Secure the chassis ground connection:
WARNING:
You must complete the ground connection before proceeding with any other PEM
connection.
a
Locate the chassis ground connector stud on the PEM front panel (see Figure 8-3 ). It is the single stud below
the safety cover.
b
Remove the nut and washer from the ground stud.
c
Apply a coat of anti-oxidant paste to the connector stud, if required.
d
Install the grounding cable. This cable is typically green or green and yellow.
NOTE:
Termination points require UL-listed 1-hole lug with a 1/4-inch hole.
e
Replace the washer and nut on the stud.
f
Secure the nut with a nut driver or torque wrench (not to exceed 4 ft/lbs).
g
Connect the opposite end of the grounding cable to the appropriate nearest grounding.