Figure 67. Removing the system battery
3
To install a new system battery, hold the battery with the positive side facing up and slide it under the securing tabs.
4
Press the battery into the connector until it snaps into place.
Figure 68. Installing the system battery
Next steps
1
Install the expansion card riser
2
If applicable, connect the cables to the expansion card(s).
3
Follow the procedure listed in
After working inside your system
.
4
While booting, press F2 to enter the System Setup and ensure that the battery is operating properly.
5
Enter the correct time and date in the System Setup
Time
and
Date
fields.
6
Exit the System Setup.
Optional internal USB memory key
An optional USB memory key installed inside your system can be used as a boot device, security key, or mass storage device. To boot from
the USB memory key, configure the USB memory key with a boot image and then specify the USB memory key in the boot sequence in
System Setup.
An optional USB memory key can be installed in the internal USB 3.0 port.
NOTE:
To locate the internal USB port on the system board, see the System board jumpers and connectors section.
Replacing optional internal USB memory key
Prerequisites
CAUTION:
To avoid interference with other components in the server, the maximum permissible dimensions of the USB memory
key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your system
.
106
Installing and removing system components
