Dell EMC PowerEdge T40, Инструкция по установке и обслуживанию

Страница: 68 / 96

2. Follow the procedure that is listed in After working inside your system
System board
Removing the system board
Prerequisites
CAUTION: If you are using the Trusted Program Module (TPM) with an encryption key, you may be prompted to create a
recovery key during program or System Setup. Be sure to create and safely store this recovery key. If you replace this
system board, you must supply the recovery key when you restart your system or program before you can access the
encrypted data on your hard drives.
CAUTION: Do not attempt to remove the TPM plug-in module from the system board. After the TPM plug-in module is
installed, it is cryptographically bound to that specific system board. Any attempt to remove an installed TPM plug-in
module breaks the cryptographic binding, and it cannot be reinstalled or installed on another system board.
1. Follow the safety guidelines listed in Safety instructions .
2. Follow the procedure listed in Before working inside your system .
3. Open the PSU assembly .
4. Remove the memory modules .
5. Remove the expansion card if installed.
6. Remove the heat sink module .
7. Remove the processor .
8. Disconnect all cables from the system board.
Steps
1. Using the Phillips #2 screwdriver remove the screws that secure the system board to the chassis.
68 Installing and removing system components