Steps
1. If applicable, disconnect the
MB_SL1
and
MB_SL2
connector.
a) To remove the
MB_SL1
and
MB_SL2
connector, hold and pull the blue pull tab.
2. Using Phillips #1 screw driver, remove the screws that secure the expansion card riser 2.
3. Holding the blue touch point, remove the expansion card riser from the chassis.
Figure 23. Removing the expansion card riser 2
Next steps
1.
Install the expansion card riser 2
Installing the expansion card riser 2
Prerequisites
NOTE:
You must install an expansion card filler bracket over an empty expansion slot to maintain Federal
Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system
and aid in proper cooling and airflow inside the system.
1. Follow the safety guidelines listed in
.
2. Follow the procedure listed in
Before working inside your system
Steps
1. Align the screw holes on the riser with the stand offs on the system board and insert it until the riser card is firmly seated in the slot..
2. Using a Phillips #1 screwdriver, tighten the screws that secure the expansion card riser 2.
48
Installing and removing system components for PowerEdge C6525
