Operating Instruction
Retractor
BAL0400-0112a-D/E/F
www.conductix.com
Seite 20 von 33
9.2
Adjusting the cable length and cable length limit
Adjusting the cable length
The retractor is delivered from the factory with a longer cable (10), Before commissioning the desired cable extension length
must
be adjusted,
1.
To extend the cable (10), pull it through the cable lock (7), The minimum distance of 100 mm shown between the cable lock
(7) and cable clamp (9) must be observed,
2.
When the desired length is reached, the pressure clamp (8) provided must press on the cable,
3.
Cut off the projecting end of the cable behind the pressure clamp (8),
Adjusting the cable retraction limit
The maximum permitted cable extension (3 m) may not be exceeded,
Hang the appropriate load and pull the cable to the desired position,
Loosen the screws on the cable clamp (9), adjust the desired cable length, and then tighten the
screws again,
The rubber bumper (13) can be moved manually, and protects the basic housing and
suspended load,
