Operating Instruction
Retractor
BAL0400-0112a-D/E/F
www.conductix.com
Seite 17 von 33
8
Retractor 040813-…, 040814-…
8.1
Adjusting the loading capacity
Before adjusting the loading capacity, hang the load onto the fully retracted cable.
Adjustment in the plus (+) direction increases the loading capacity.
Adjustment in the minus (-) direction reduces the loading capacity.
When the correct setting is reached, the suspended load can easily be pulled into the desired position, and returns
to its original position after release.
Retractors are shipped from the factory at the maximum load setting. Subsequent adjustments must be recorded in
writing so that the maximum and minimum permitted loads are observed later. See the following model-specific
specifications.
Failure to comply with this instruction will destroy the spring inside the housing!
When the spring ratchet (11) is pressed, the spring tension will be exerted on the adjustment tool.
Hold the adjustment tool firmly!
The following tool is needed for making adjustments:
Allen wrench (4 mm)
Insert the Allen wrench into the spring ratchet (11) and push inwards (hold tight!). Using the
Allen wrench, make the desired adjustment within the permitted adjustment range.
Column "X" = maximum permitted number of turns in the minus direction,
starting from the factory maximum load setting
Type
X
040813-02x2,5
6.4
040813-03x2,5
5.2
040814-02x2,5
6.4
040814-03x2,5
5.2
