Defender Security 82-13285, Инструкция по установке и эксплуатации

Страница: 22 / 23

18 / 19
DWELL TIME <SECS> 5 ~ 250 Duration (in seconds) of the dwelling time on each presetting.
PRESET LIST 1 ~ 3
Value 1 selects the first group of Presets from 1 to 10, value 2
selects the second group from 11 to 20, value 3 selects the
third group from 21 to 30.
The following 10 digits (1/10) are used to switch the
corresponding preset in the corresponding ten (1-10, 11-20,
21-30) either on or off (1=
ON
; 0=
OFF
).
5. TROUBLE SHOOTING
Problem Possible Reason Solution
Wrong wire connections Check and reconnect wires
Wrong or bad power source Change power source
Fuse broken. Change fuse
Power on normally but no video
signal
Power cable is disconnected Reconnect power wiring
Address, protocol, and baud rate is
not correctly set Check and set the parameters
again.
Pan/Tilt not initializing when power
on
RS-485 cable is not correctly
connected
Check and reconnect RS485
cable
Video cable is wrong Check and reconnect video
Video is not stable
Power source is wrong Change the power source
Control center is not stable RS-485 wiring error Check and reconnect the RS485
Table 2
6. NOTES
1. Careful Transport
Transport, storage and installation process, we need to prevent stress, severe vibration and
damage to the product immersion.
2. Do not demolish unauthorized Camera
Do not remove screws or protective cover, machines, there is no user to repair parts. The
work should be qualified maintenance personnel.
3. Be careful the installation of zoom camera
To be especially careful, light-light, do not force squeezing movement and the structural
components, so as to avoid the ball machine trouble. For security reasons, do not cover the
ball is not installed electricity.
4. Power, video lines and control lines
Power lines, video lines and control lines preferable to use shielded cable and is independent
of routing, can not blend together with other lines.
5. ELECTRICAL SAFETY
In use must comply with all electrical safety standards, the ball machine or signal
transmission line should work with high-voltage equipment or cables to maintain a sufficient
distance (at least 50 meters), if necessary, do a good job against lightning, surge and other
protective measures.
6. Cleaning
Cleaning the camera housings, please use the dry soft cloth, such as severe dirt, use neutral
cleaning agent gently wipe. Do not use strong or with abrasive cleaning agents, so as not to
scratch jacket, affecting image quality.
7. Note that strictly sealed to prevent liquid splashing into or foreign bodies falling into the
ball machine, otherwise it will result in permanent damage to the device.
8. Do not exceed the limits of temperature, humidity, the use of state of the camera.
Ball machine use temperature of -25
℃
to 70
℃
, humidity of less than 90%.