Defender Security 82-13285, Инструкция по установке и эксплуатации

Страница: 18 / 23

14 / 19
CAMERA Camera parameter programming submenu
CRUISE SETTING Cruise programming submenu(refer to Section 4.2.5 . ).
DISPLAY SETUP used to enable the labels to be displayed for the various camera functions.
RESTORE FACTORY DEFAULT
This performs a total reset and loads the default settings. The operations may
take a few seconds (approximately 20 seconds): the message “
WAIT
” will
appear on the monitor.
REBOOT SYSTEM
restarts the device without clearly the settings performed by the user. The
camera is repositioned.
EXIT Exit the OSD menu
Simply press
BACK
and use
OPEN
to go back to the previous level menu.
To completely exit a menu on any level, simply select
EXIT
and use the
OPEN
command.
4.2.1. SYSTEM INFORMATION
In the first level menu, select
SYSTEM INFORMATION
to display information concerning the protocol, the camera
address and the presetting number.
Screen 2: System Info
The information in this menu cannot be edited.
4.2.2. ADDR SETTING
On the menu of 3.1MAINMENU
，
up/down the controller
，
move the cuser to <ADDR SETTING>
，
Press OPEN
Button
，
step in 3.3ADDR SETTING the setup address menu
。
Screen 3: ADDR SETTING
Up and down the controller
，
the value of ADDR TYPE can choose HARD(Hard Address,use stir code to stir)
and SOFT(soft aadress,can setup the menu)
，
after the installation
，
can revise the address of the camera by
remote
。
ADDR SOFT
：
After ADDR TYPE choose SOFT
，
can confirm the address setup of the camera
。
4.2.3. MOTION
ADDR SETTING
ADDR TYPE HARD
ADDR SOFT 3
ADDR HARD 1
BACK
EXIT
SYSTEM INFORMATION
COM 9600,N,8,1
ADDRESS 1
PROTOCOL PELCO-D
PRESETS 255
SOFTWARE VERSION V5.2
BACK
EXIT