DeDietrich DPE7610 Series, Руководство по установке и использованию

Страница: 15 / 24

Identify your type of hob by
comparing the number and layout of
the burners on your appliance with the
illustrations (0.1.1) and (0.1.2) .
Make a note of the references of your
appliance on the "After-Sales Service
and Customer Relations" page so that
you can readily find them in future
(6.1.1). This page also explains where
to find them on your appliance.
1.1 – FITTING :
This worktop must be at least 3 cm
thick and heatresistant or else coated
with a heat resistant material.
If a horizontal partition is installed
under the hob, it must be positioned
between 10 and 15 cm below the
worktop.
Under no circumstances keep any
sprays or pressurised containers in any
compartment
below the hob (see
"Safety guidelines“ chapter).
Follow the guidelines in the sketch
(1.1.1).
o
Remove the "pan supports", burner
caps and burner heads, noting their
original positions.
o
Turn the hob upside down and
place it carefully over the top of the
base unit, so as not to damage the
knobs or igniters.
o
To ensure a good seal between the
body of the hob and the worktop, stick
the foam seal
around the edge of
the body, before installing the hob
(1.1.3).
Place the hob over the opening in the
base unit, taking care to pull the hob
towards you.
Fit the burner heads, caps and pan
supports.
Connect your hob to the gas (see "Gas
connection"
section) and to the
electricity (see "Electrical connection“
section).
If you wish,
you can secure the hob in position,
using the four fixing clamps
and
screws supplied supplied (1.1.5) fixing
them
to the four corners of the
housing. It is essential that you use the
holes provided for the purpose, as per
the drawing (1.1.4).
Stop
screwing when the clamp
starts to bend.
Do not use a power screwdriver.
23