DeDietrich DPE7610 Series, Руководство по установке и использованию

Страница: 16 / 24

1.2 – ELECTRICAL CONNECTION :
Your hob is supplied with a H05V2V2F
- T90 3-core (phase, n earth)
mains cable, section 1 mm2) after
sales ref.: 77X3767 (6470.1516) and
must be connected to a 220-240 V~
single phase mains supply via a phase,
nearth socket meeting standard
IEC 60083 or an omnipolar isolator
with a contact air gap of at least 3.5
mm.
The plug must be accessible after the
hob is installed.
The protective conductor
(green/yellow) is connected to the
earth terminal on the hob and must
also be connected to the installation's
earth terminal
. The fuse for the
installation should be 10 amperes
(1.2.1).
If the supply cable is damaged, it must
be replaced by a cable or special set
available from the manufacturer or its
after-sales department.
So that you can find the
references for your appliance without
difficulty in the future, we recommend
that you make a note of them on page
(6.1.1)
"After-sales service and
customer relations“ (that page also tells
you where to find them on your
appliance).
1.3 – GAS CONNECTION :
If the hob is to be installed above an
oven
or if other nearby heating
appliances could heat and damage the
gas hose, then it is essential that a
rigid pipe is installed instead.
If a flexible hose is used (as is the case
of butane gas) then it must not be
installed in a place where it may be in
contact with a moving part of the
kitchen unit or a location likely to get
cluttered.
No flexible hoses with a limited
service life may be longer than 2
metres and must be accessible for
inspection along their entire length.
They must be replaced before their
expiry date (printed on the hose).
Whatever
means of connection is
chosen, make sure that it is gastight
when installed, using soapy-water. In
France, you must use a hose or pipe
stamped NF Gaz .
The gas connection must comply with
the regulations in force in the country
where it is installed.
• Mains natural gas (1.3.1).
For your safety, you must choose only
one of the following three connections:
o
Connection via a rigid copper
pipe with mechanical screw
connectors (½" gas standard).
• Connect directly on to the elbow on
the appliance.
24