Dedicated Micros DV-IP HD, Инструкция по установке и эксплуатации

Страница: 97 / 128

draft
Dedicated Micros ©2008
D
V-IP HD
Optical Zoom Limit Select to limit the Oracle Domes optical zoom function. By default
‘100x’ is selected and the camera can zoom to its maximum
capabilities. The optical zoom function can be limited to between
75% and 100% magnification.
Coax Gain If the Oracle Dome camera is connected to the unit via coaxial
cabling. The coax signal can be improved by increasing the
coaxial gain settings. Select a percentage figure between 1 and
100 until the optimum image quality is reached.
Coax lift If the Oracle Dome camera is connected to the unit via coaxial
cabling. The coax signal can be improved by increasing the
coaxial lift settings. Coaxial lift differs from coaxial gain as only the
high end of the signal spectrum is effected. Select a percentage
figure between 1 and 100 until the optimum image quality is
reached.
White Balance The Oracle Domes White Balance feature enables the camera to
compensate for different lighting scenarios which can effect the
colour quality of the displayed image. Select ‘Auto’ for the camera
to auto-compensate for white balance depending on current view.
Select ‘Indoor’ to permanently set for best results in an indoor
setting. Select ‘Outdoor’ to permanently set for best results in an
outdoor setting.
Exposure The Oracle Domes Exposure setting can be set to maintain
optimum contrast settings for the viewed image/camera location.
Select ‘Full Auto’ for the camera to auto-compensate for best
exposure settings depending on current view. Select ‘Manual’ to
manually configure exposure settings. Select ‘Shutter Priority’ to
manually enter the shutter speed.
Shutter Speed If the Exposure feature is to be manually configured, enter the
shutter speed settings.
ICR The Oracle Dome camera is fitted with an Infrared Cut function,
This feature helps remove excessive infrared light which can
significantly reduce image quality. Select ‘On’ for this function to
permanently be active, ‘Off’ to deactivate, or ‘Auto’ for the unit to
only use the function when required.
ICR switching can also be triggered in response to an alarm
input. Ths allows a photocell sensor to be used to control when a
camera should switch from normal to low light mode (for optimal
performance). Alarms 1-4 can be selected as the controlling alarm
input for this action, refer to ‘Alarm Settings-Alarm Input’ for more
information.
UTP Boost If the Oracle Dome camera is connected to the unit via twisted
pair cabling. The UTP Boost function can be activated to improve
signal strength.