Dedicated Micros DV-IP HD, Инструкция по установке и эксплуатации

Страница: 8 / 128

draft
Dedicated Micros ©2008
D
V-IP HD
Installing the Unit
Before you start
Check the contents of the box
Remove all items from the packaging and check the items listed below are present.
• DV-IP HD DVR
• IR Remote Control
• IR Remote Control Extender
• Mouse
• Power Leads
• DV-IP HD Software disc
If any of these items are missing, please contact Dedicated Micros Technical Support team.
Note: Before installing the DV-IP HD carefully read all Safety Instructions and the following
information on where the unit should be located.
Available Accessories
The following accessories can also used in conjunction with the DV-IP HD.
• KBC1 Keyboard
• KBC2 Keyboard
• Managed Storage Unit - Extend storage capacity to 5TB
• Managed Continous Archiving - Mirrored RAID1 storage unit
For further information about any of the above products, please contact Dedicated Micros customer
services in your region.
Choosing a location for installation
• The DV-IP HD is designed to be desk, shelf or rack mounted. Rack mounting brackets
are available as an optional accessory.
• Ensure the DV-IP HD unit is properly ventilated to protect from overheating.
• Ensure there is a 3cm gap on both sides of the unit.
• Ensure the IR receiver on the front of the unit faces the operator position, and is not
more than 3 metres (
10
feet) from the operator.
An IR Remote Control Extender is also
available.
• Ensure the unit is not located anywhere it could be subject to mechanical shocks.
• The unit should be located in an area with low humidity and a minimum of dust. Avoid
places like damp basements or loft spaces.
• If the unit is to be installed in a closed assembly, the maximum operating temperature
must not exceed 40°C (104°F).
• Ensure there is reliable earthing of the mains outlet when fitted to supply connections
(other than direct connection to the branch circuit).
• Any branch circuit supplying the unit must be rated at 15Amps.
• It is recommended that an uninterrupted power source be connected to the unit in case
of power failure (to ensure continuous operation of the unit).