29
Care and maintenance
3. Unscrew the paint tub (
8
) from the spraying unit (see
Fig. A
and K
).
4. Dispose of the remaining material properly or put it back into the
material can.
5. Pull the intake tube (
25
) and the ventilation tube (
24
) down
and out of their catches on the spraying unit. Take care to pull out
the whole multi-part ventilation tube (in one piece).
6. Use a cloth to remove coarse dirt and paint residues from out of
the paint tub.
7. Use the cleaning brush (
17
) to remove coarse dirt or blockag-
es from the inside of the intake tube, ventilation tube and the
mountings of the spraying unit.
8. Re-insert the intake tube and ventilation tube into the corre-
sponding mounts on the spraying unit from underneath. Make
sure that the intake tube is correctly aligned when you do: The
hook at the top end of the intake tube must run inside the guide
groove on the corresponding mount in order for the intake tube
to be correctly seated.
9. Fill the paint tub with water or solvent.
10. Screw the paint tub back onto the spraying unit from
underneath.
11. Fit the spraying unit back on the motor unit as described in the
section “Attaching/replacing the spraying unit”.
12. Connect the power cable to a power socket and switch on the fine
paint sprayer, then spray the solvent or water into a container or
cloth.
13. Keep repeating until only clear solvent or water comes out.
14. Then fully empty the paint tub and take apart the equipment
again for it to dry.
Layout_DS_FSS_500_EX_UK_SPK7.indd 29
Layout_DS_FSS_500_EX_UK_SPK7.indd 29
19.11.2020 15:15:29
19.11.2020 15:15:29
