Decatur DragonEye Compact, Руководство пользователя

Страница: 27 / 40

D
ra
go
n
Ey
e C
om
p
ac
t
U
se
r’s
M
an
ua
l
27
At this point you have either entered the reference distance or
determined it by shooting the reference objects . If the reference
distance is acceptable, press Enter
. Otherwise press the Menu
button to "escape" from the menu system .
Once the reference distance is accepted, the side display will show
the reference distance and instructions to "Click Trigger to Start" . Click
the trigger when a vehicle crosses the first reference object point to
start the timer . Click the trigger a second time to stop the timer . The
unit will display the average speed of the vehicle on the side panel .
To measure the average speed of additional vehicles, simply click the
trigger once to clear the old reading and the timer is now re-armed
for a new reading .
6.7 Load Defaults
The factory default settings for the LIDAR can be restored at any time
by pressing
then selecting "Load Defaults" using the up/down
arrows and pressing Enter . This command restores
default brightness and audio levels as well as settings for Minimum
and Maximum range values .
6.8 ECCM Control
The ECCM menu allows the operator to temporarily disable the
LIDAR's Electronic Counter-Counter Measure (anti-jamming) system .
To activate or disable the ECCM, press
then use the up/down
arrows to select "ECCM" and press . Then use the
up/down arrows to select "Active" or "Disabled" and press to
confirm your selection . If ECCM is disabled, the LIDAR unit will return
to ECCM "Active" if it is not in use for a few hours, if the batteries are
replaced, or if "Load Defaults" is selected .
• While the DragonEye Compact is fully functional with
ECCM set to "Disabled", the ECCM setting should be left
in the "Active" state during normal operation to give
the full protection against laser detectors and jammers .