THE SERVO AND CABLE
2
3
Hold the open servo with the circuit board facing upwards. Fetch the
servo cable fitted with protective pads in the previous stage, and press
one of its connectors into the socket circled in red, as you have done
before. It does not matter which end of the servo cable you use.
Gently lift the cover away, taking
care not to force it or damage
the circuit board underneath.
1
Take out the four screws holding the servo’s removable
cover in place, and keep these safely to one side.
As ever, it is very
important that the
electronic parts
exposed by removing
the servo’s cover are
not touched in any
way. Make sure to hold
the open servo by its
sides, and if you put it
down on your work
surface during the
assembly, do this with
the open side facing
upwards.
4
Pass the free end of the servo
cable through the circular hole in
the removable cover, as shown.
5
6
Press the cover back into place
on the servo’s main housing.
Fasten the cover back into place
with all four screws, but only
lightly, as you will be removing
them again at a later stage.
TIP!
TIP!
This servo cable had
protective pads fitted
to its connectors in the
previous stage, but if you
find it difficult to attach
with a pad in place, it is
possible to fit the pad
afterwards. If you choose
to do the assembly this
way, be especially careful
not to press down on the
circled projection, next to
the cable, as you do so.
329
