C O N N E C T O R S A N D P I N O U T S
Data Device Corporation
BU-67121W Manual
Rev B – 6/16
46
8.2.2 J5 Signal List
J5 will be an open PMC slot. If using a DDC card, please refer to the card’s manual
for the signal list.
8.2.3 J6 Signal List
J6 will be the second open PMC slot. If using a DDC card, please refer to the card’s
manual for the signal list.
8.3 Connector Pinouts
Refer to Table 6. AIC Signal List J1 – J4 & Ethernet, USB, VGA, RS-232 for names
and descriptions of the various pins.
Mini PCI-e Site A will route it’s signals to J1 and J2. Mini PCI-e Site B will rout its
signals to J3 and J4.
When using DDC cards, a FPC cable will allow a user to route the DDC card signals
to the front connectors.
If using a non-DDC card then you will have to create your own cable that connects to
the onboard header. Section 4.3.3 and 4.3.6 will show you the pins for the onboard
header and how they map to the front connectors.
8.3.1 AIC J1 Connector
Figure 38. AIC J1 15-Pin D-Sub Connector
When populating the Mini PCI-e site A with DDC cards, the following table shows
which signals come out of each pin on the connector.
