You will need just few basic tools and materials to
finish your Arrow V.5:
Sharp hobby knife, file ,1.5mm dril, piece of
sanding paper, scizors, screwdriver, solder,
Donatas Design beveling tool.
Mercury Adhesives foam friendly CA glues
(M100F), Mercury Adhesives Accelerator MH 16
M3 medical tape for control surface attachment.
Bui lding:
Using sharp knife split fuselage.Do not throw derpon "trash" (servo cutout holes). For example if
you decide to use two aileron servos you can glue back inside fuselage this small piece and avoid
having ugly hole.
3
Required tools and ad hesives:
Make sure you remove all steps
that were connecting fuselage.
Repeat this procedure for all parts.
If you try to build plane light, here is one trick. „Shave“,
end’s of 0,5mm flat carbon. You will save some weight
and will have very useful thin carbon for further building.
Next thing is reinforcing some critical part
s
.
H
ere you can see aileron compensator
reinforcement with thin carbon.
Ussing D
onatas
D
esign
beveling tool cut
aileron edge, for easy deflection down
(
when
it is attached to wing
), and great clean look
.