Hollywood DV-Bridge User’s Guide • Using Hollywood DV-Bridge Without a Computer • Page 45
Connecting an Optional Preview Monitor
When you conver t Analog Video to DV, there are three ways to connect a preview monitor.
Method A:
If an analog output device is not connected to the Hollywood DV-Bridge during
the conversion process, connect the TV monitor as follows:
1.
Connect an RCA video cable (yellow) or S-Video cable (black) from the Video Out con-
nector on the back of the Hollywood DV-Bridge to the corresponding Video In connec-
tor on the TV monitor.
2.
Connect an RCA audio cable (red and white) from the Audio Out connector on the back
of the Hollywood DV-Bridge to the Audio In connector on the monitor.
Note:
Your audio cable may have separate connectors for left and right, or the connec-
tors might be joined as shown in the illustration below. Remember that you need to
use a Y-adapter if the analog camcorder or VCR only supports mono output.
IMPORTANT:
Make sure that the monitor is set up properly to receive a video signal. It
might need to be set to “Line In,” “L1,” “L2,” “Aux” or a similar channel. Check the mon-
itor’s documentation for specific details.
Hollywood DV-Bridge
TV
Optional
Preview Monitor
Audio Out
Audio In
RCA Video Out
RCA Video In
S-Video Out
S-Video In
Back
Or
(To AC Power)
