Hollywood DV-Bridge User’s Guide • Using Hollywood DV-Bridge With a PC • Page 27
Connecting an Optional Preview Monitor
Analog or DV Output Configurations
During analog output or DV output (with an analog output device connected), if the con-
nectors on your camcorder or VCR and your monitor are compatible, you can connect a
preview monitor as follows:
1.
Connect one end of an RCA (composite) video cable (yellow) or S-Video cable (black)
to the Video Out connector on the camcorder or VCR.
2.
Connect the other end of the cable to the Video In connector on the TV monitor.
3.
Connect an RCA audio cable (red and white) from the Audio Out connectors on the
back of camcorder or VCR to the Audio In connectors on the monitor.
Note:
Your audio cable may have separate connectors for left and right, or the connec-
tors might be joined as shown in the illustration below. Remember that you need to
use a Y-adapter if your monitor only suppor ts mono input.
If the TV monitor does not suppor t the kinds of cables shown below, you may be able
to connect it using a coaxial cable. Many VCRs and most TVs have this kind of connec-
tor, and many VCRs come with a coaxial cable.
Connecting the TV monitor to the camcorder or VCR results in the configuration shown
below
IMPORTANT:
Make sure that the camcorder or VCR and monitor are set up properly to
receive a video signal. It might be necessar y to set a camcorder to VTR mode, while a
VCR or monitor might need to be set to “Line In,” “L1,” “L2,” “Aux” or a similar channel.
Or, if a monitor is connected to a VCR with a coaxial cable, you might need to set the
monitor to channel 3 or 4. Check each device’s documentation for specific details.
Hollywood DV-Bridge
Audio Out
Audio In
RCA Video Out RCA Video In
S-Video Out
S-Video In
Back
Or
(To AC Power)
TV
VHS
Audio Out
Audio In
RCA Video Out RCA Video In
S-Video Out
S-Video In
Or
Coaxial Out
Coaxial In
OR
Optional Preview Monitor
Analog Camcorder or VCR
