Hollywood DV-Bridge User’s Guide • Using Hollywood DV-Bridge With a
PC
• Page 29
Method B:
Connect the monitor to the DV camcorder or VCR as follows:
1.
Connect an RCA video cable (yellow) or S-Video cable (black) from the Video Out con-
nector on the camcorder or VCR to the Video In connector on the TV monitor.
2.
Connect an RCA cable (red and white) from the Audio Out connector on the back of
camcorder or VCR to the Audio In connector on the monitor.
Note:
Your audio cable may have separate connectors for left and right, or the connec-
tors might be joined as shown in the illustration below. Remember that you will need to
use a Y-adapter if the monitor only suppor ts mono input.
If the TV monitor does not suppor t the kinds of cables shown above, you might be able
to connect it using a coaxial cable. Many VCRs and most TVs have this kind of connec-
tor, and many VCRs come with a coaxial cable.
IMPORTANT:
Make sure that the camcorder or VCR and monitor are set up properly to
receive a video signal. It might be necessar y to set a camcorder to VTR mode, while a
VCR or monitor might need to be set to “Line In,” “L1,” “L2,” “Aux” or a similar chan-
nel. Or, if a monitor is connected to a VCR with a coaxial cable, you might need to set
the monitor to channel 3 or 4. Check each device’s documentation for specific details.
Outputting Video
For instructions on outputting your DV or analog video to a camcorder or VCR, see your
MovieStar 5 User’s Guide
.
Hollywood DV-Bridge
DV Camcorder or DV VCR
VHS
DV Out
DV In
Front
TV
Optional
Preview Monitor
Audio In
Audio Out
RCA Video In
RCA Video Out
S-Video In
S-Video Out
Or
Coaxial In
Coaxial Out
OR
