DAYLIFF DSTEAM90, Инструкция по установке и эксплуатации

Страница: 16 / 24

13
8. “ “This button has 2 functions; if the generator is off this button can be used to
drain the generator manually. If the generator is switched on it can be used to select
the steam on demand operating mode.
9. When the preset temperature for the steam room is reached 2 of the 3 elements will
switch off allowing just 1 to continue heating to maintain the temperature. Elements
will cycle on and off to maintain the temperature to within approximately 2.5 degrees
above or below the preset requirement.
10. Boil dry protection – If the water supply is discontinued the water level indicator LED
turns red and the steam generator stops immediately.
11. The “ “ button can output AC230V to power the transformer for a 12V steam
room lamp.
Drain
Model
Light
12. “ “ button has 2 functions; it can be used to power a fan if fitted and can also be
used during the temperature or time setting procedure to confirm the settings (see
further details below).
13. “ “ button has 2 functions; it is used to set the time and temperature settings and to
start the descaling operation (see further details below).
14. The display temperature can be changed from Celsius (default) to Fahrenheit by
altering the settings of the JP1 pins on the circuit board.
Fan
Enter
Set
Clean
5.2 Setting Time and Temperature
0
The steam generator default settings are 40 C temp and 1 hour of operation which can
be adjusted as follows;
The memory is lost and reverted back to the factory default
settings when the power is cut off.
CAUTION
Fan
Enter
Fan
Enter
Set
Clean
Set
Clean
1. To set time: press “ “ key and the time display window will flash - press “ “ or “ “
to adjust the time, every press increases or reduces by 5 minutes, once the desired
setting is achieved press “ “ the window will stop flashing. Time may be adjusted
from 10 to 240 minutes. Exceeding 240 minutes the display will show “NO”
meaning no time limit.
2. To set temperature press “ “ twice. The temperature window will flash, enter the
required temperature by pressing “ “ or “ “ to adjust - every press will increase or
reduce by 1
℃
. Temperature is adjustable from 30
℃
-60
℃
, press “ “ key and
the window will stop flashing.
3. Auto-descaling can only operate when the steam generator is in OFF mode i.e. the
boiler has finished steaming; the water has drained and flushed, the drain LED will be
off. Before auto-descaling can commence, a supply of dilute citric acid liquid must
be connected from a storage vessel positioned at least 500mm above the steam
generator. For the dilution ratio refer to the information supplied with the citric acid.