ENGLISH
2
This manual describes the Voyager, installation and operation.
Package Contents
Your Voyager package includes the following
1
Voyager 60 / Voyager 300/ Voyager 125H Local Unit
1
Voyager 60 / Voyager 300/ Voyager 125H Remote Unit
1
Power Transformer and mains lead
1
CPU Cable Set
1 User
Manual
•
Use only the power transformer supplied with this product.
•
Note—The Voyager 60 uses a 5vdc PSU on both local and remote (optional on
local), the Voyager 125H/300 uses a 9vdc PSU on the remote and 5vdc on the local
(local power optional and requires a special PS2 power cable)
Cable Requirements
Cables to connect the Voyager Local unit to your PC’s system unit are supplied in the
package. Your keyboard, monitor and mouse will plug straight into the Voyager
Remote Unit. The Local Unit to Remote Unit connection cable is not supplied; if you
do not have suitable CAT 5, 5E or 6 UTP or STP cable fitted at you site, please consult
your dealer.
The Local and Remote Units are connected by industry standard structured cabling
(Category 5, 5E or 6 UTP/STP, 4-pair) terminated with RJ45 connectors.
The cable used should be solid trunk cable.
Stranded patch cable will give poor
results over longer distances.
The connector wiring
must
be to EIA/TIA 568.
Refer to the wiring chart later in the
manual.
Note:
Failure to wire the twisted pairs correctly will impair the video quality
dramatically and / or prevent correct operation.
This Voyager extender is designed for use up to a maximum cable length of either
60m/180ft (Voyager 60) or 300m/1000ft (Voyager 300) or 125m (Voyager 125H) At
this length the video quality should still be acceptable even at a screen resolution of
1024x768 (75Hz) and 1600x1280 (Voyager 125H).
Although a single continuous length of interconnect cable is preferable, operation is
possible through multiple patch panels. However, the more patch panels the cable is
routed through, the greater the chance of video signal degradation.
GETTING
STARTED
