Dawson 5600D EMV550v3, Инструкция оператора/Перечень запасных частей

Страница: 14 / 53

6.0 MAINTENANCE
The Excavator Mounted Vibrators have been designed to give years of trouble free service.
Providing the equipment is treated with respect and the basic maintenance procedures are adhered
to there will be little work additional work required.
The most important points are correct installation on good quality excavators, cleanliness when
connecting to the excavator’s hydraulic system and regular gearbox oil changes using appropriate
oils - again cleanliness is paramount.
Visual inspection of the EMV by a competent person on a daily basis and before being taken into
service can prevent many potential problems from occurring. Ensure that lifting accessory test
certificates are correct and valid at all times.
•
All service and maintenance work must be carried out by qualified personnel using
original Dawson parts. The use of other parts will invalidate the whole warranty for the
equipment.
• The equipment should be inspected at ground level only and should be positioned so as
to be stable at all times.
•
Secure the equipment against unexpected starting during the maintenance process.
• The equipment should be inspected by a Dawson technician or by one of their approved
distributors once a year or every 1000 working hours.
6.1 Daily Maintenance.
a. Grease the two grease points on the EMV550 – one on the Saddle Swivel and
the other on the side of the Clamp Body. Two or three pumps with a
molybdenum-based grease will be adequate.
b. Check visible screws, bolts, fittings etc for tightness.
c. Visually inspect all hydraulic hoses and fittings for leaks or damage.
d. Check the gear oil level in the vibrator. The level must be half way up the sight
glass.
e. Inspect the lifting chain and chain clamp for damage. The chain and clamp
should be in good order, free from any structural damage or permanent
deformation of any kind. The chains anchorage point should be in good order
showing no signs of damage, wear or cracking. Remember
if in doubt change it
–
Chains require new test certificates to be recorded when changed!
f. Inspect the condition of the Hard Jaws. To be acceptable these should look to
be in almost as new condition. The teeth on these pads have some flats on them
when new (approximately 1.5x1.5mm). Over time they will round off, flatten out
more and even become chipped. If not changed when required they will loose
their grip on the pile during driving and certainly during extraction. Besides
causing a reduction in performance this can become a safety hazard. We define
the following wear limit: