David Clark 9500 SERIES, Руководство по установке

Страница: 9 / 31

19532P-76 (09-15) of 22 5
1. Mounting the Master Station
Parts/Tools Required
U9500 Master Station (40794G-03)
Philips-Head Screwdriver
Slotted Screwdriver
11/32-inch nut driver or wrench
Tape Measure
Pencil
Drill
3/16” Drill Bit
Master Station Mounting Kit (40688G-62)
Procedure
Location Considerations
Choose a location on a vertical wall that will allow access by the operator and also allow the
cover to be removed should adjustments be necessary. The ¾” cable fittings should be facing
down toward the deck to reduce the chance moisture entering the enclosure. The Master Station
is weather-tight, however the mounting location should chosen to minimize direct water exposure.
Mounting
Using a Philips screwdriver, remove the 4 screws on the cover of the Master Station and lift
off the cover. Observe the 4 mounting holes in each corner, as shown in
Figure 2 .
Position the Master Station Drilling Template on the mounting surface and mark each hole
with a pencil.
Confirm the location and carefully drill each hole using the drill and 3/16” bit.
Position the Master Station on the mounting surface and insert a 3/16” machine screw into
each mounting hole.
On the backside of the mounting wall, use a flat washer, a lock washer, and a nut to secure
the Master Station (
Figure 2 ).