User’s Guide
Quick Reference
2.1.1 Two Speed (no 24hr circulation pump)
Section 2.0
2.1.2 Two Speed (24hr circulation pump fitted)
Pump 1B button: Push to change pump speed (LOW, HIGH)
2.1.3 Single Speed (no 24hr circulation pump)
Pump 1B button: Push to turn ON/OFF additional pump (if fitted)
2.1.4 Single Speed (24hr circulation pump fitted)
Pump 1A button: Push button to turn pump ON/OFF
Page 4
Pump 1A button: Push to turn pump ON/OFF
Pump 1B button: Push to change pump speed (LOW, HIGH)
Pump 1B button: Push to turn ON/OFF additional pump (if fitted)
Pump 1A button: Push to change pump mode (PUMP AUTO, MANUAL ON ,MANUAL OFF)
Pump 1A button: Push to change pump mode (PUMP AUTO, MANUAL ON ,MANUAL OFF)
2.3 Aux (Pump, Blower, Light)
Push button to turn Aux output ON/OFF
For more detailed information please see section 3.
2.2.2 Two Speed Pump
2.2.1 Single Speed Pump
Pump 2A button: Push to turn ON/OFF additional pump (if fitted)
Pump 2B button: Push to turn ON/OFF additional pump (if fitted)
Pump 2A button: Push to turn pump ON/OFF
Pump 1B button: Push to change pump speed (LOW, HIGH)
2.1 Pump 1 Operation
2.2 Pump 2 Operation
For more detailed information please see section 4.
For more detailed information please see section 3.
9. LD.
DEFAULTS
- - - -
(SET)
(
)
(
)
[NO]
(
)
(
)
- - - -
ARE YOU SURE?
Push 9
Scroll to SET
NO
[YES]
[
]
1. SET TEMP
2. USER TIMER
3. CLOCK
4. USER ALARM
5. SLEEP TIMES
6. MAINT TIMERS
7. MISC OPTIONS
8. ADV. OPTIONS
9. LD. DEFAULTS
Page 29
Select MAIN menu then push UP button nine times
7.10 Load Factory Default Settings
The load defaults option provides a way of restoring all factory default settings. These include obvious set up
parameters such as set temperature and sleep times but also settings such as preferred light mode, light effect
speeds and blower speed will be restored to their factory defaults. Only use this option if you are absolutely sure it is
necessary.
7.10.1 Restoring Factory Defaults
1) Select the LD. DEFAULTS item from the main menu.(see below for details)
2) Press the SCROLL button. Note that the confirmation prompt uses a very short timeout (approximately three
seconds) and as such you will have to execute the following steps relatively quickly.
3) Press the UP or DOWN button to select “YES”.
4) Press the SCROLL button to load the defaults. The display will temporarily show “DEFAULTS LOADED” to
confirm that defaults have been loaded.
Notes
1) After the defaults have been loaded, it takes approximately 10 seconds for the controller to save them. Do not
turn off the power before this period elapses.
2) The clock hour, minute and weekday will not be reset when you load the defaults
