5: Testing and Troubleshooting
TW7201I-MS
5-5
2. Check the audio signal received at the codec IC J11 on the DHSL Modem
board. The codec chip converts the audio to and from digital information
(Rx on J11 pin 2 and Tx on J11 pin 5).
3. Check the audio signal transmitted from the DHSL Modem board at U15C
pin 8. This signal goes to the front panel speaker through the Front Panel
Processor board.
4. Check the audio signal at the volume potentiometer and on the wiper (J7
pin 1 and 2).
5. Check for the audio signal at the audio amplifier output on the Front Panel
Processor board (U14 pin 4).
6. Check for the audio at the speaker on the Front Panel Processor board (J5
pin 2).
5.2.4
Communication
Between
TW7201I and
TW7000
If there is no communication between the TW7201I and the TW7000
transceiver:
1. Verify the backlight and
PWR OFF/VOL
switch are operational. This
indicates the Front Panel Processor board is functional.
2. Cycle power to the transceiver and TW7201I. Verify the TW7201I is
receiving audio from the transceiver. If the remote head is receiving audio,
this indicates the DHSL modems are communicating.
3. Check the transceiver DHSL Modem board, configuration and cable.
Содержание TW7201I
