Datex-Ohmeda S/5 FM, Руководство пользователя

Страница: 5 / 94

3
3
Safety precautions
These precautions refer to the entire system. Warnings and cautions specific to parts of the system can be found in the relevant section.
Warnings
A WARNING indicates a situation in which the user or
the patient may be in danger of injury or death.
•
Connect only one patient to the monitor at a time.
•
Do not use the monitor without manufacturer approved
mounting attached.
•
Vibrations during intrahospital transport may disturb SpO
2
, ECG,
impedance respiration, NIBP and InvBP measurements.
•
Use only hospital-grade grounded power outlets and power cord.
•
Some equipment malfunctions may not generate a monitor
alarm. Always keep the patient under close surveillance.
•
To avoid explosion hazard, do not use the monitor in presence of
flammable anesthetics.
•
Do not use the monitor in high electromagnetic fields (for
example, during MRI.)
•
Do not connect any external devices to the system other than
those specified.
•
Do not touch the patient, table, instruments, modules or the
monitor during defibrillation.
•
If the integrity of the external protective earth conductor
arrangement is in doubt, use the monitor with battery operation.
•
After transferring or reinstalling the monitor, always check that it
is properly connected and securely attached.
•
When detaching modules, be careful not to drop them. Always
support with one hand while pulling out with the other.
•
Use only accessories, including mounts and batteries, and
defibrillator-proof cables and invasive pressure transducers
approved by Datex-Ohmeda. For a list of approved supplies and
accessories, see the “Supplies and Accessories” catalog
delivered with the monitor. Other cables, batteries, transducers
and accessories may cause a safety hazard, damage the
equipment or the system, result in increased emissions or
decreased immunity of the equipment or system or interfere with
the measurement. Protection against cardiac defibrillator
discharge is due in part to the accessories for pulse oximetry
(SpO
2
), temperature (T) and invasive pressure (P) measurement.
•
Single-use accessories are not designed to be re-used. Re-use
may cause a risk of contamination and affect the measurement
accuracy.
•
Do not incinerate a battery or store at high temperatures, as it
will explode.
•
The monitor or its components should not be used adjacent to or
stacked with other equipment. If adjacent or stacked use is
necessary, the monitor and its components should be observed
to verify normal operation in the configuration in which it will be
used.
•
Pins of connectors identified with the ESD warning symbol
should not be touched. Connections should not be made to
these connectors unless ESD precautionary procedures are
used. See the "User’s Reference Manual" for details.
•
The system may be interfered with by other equipment, even if
that other equipment complies with CISPR emission
requirements.
•
If liquid has accidentally entered the equipment, disconnect the
power cord from the power supply and have the equipment
serviced by authorized service personnel.
•
If the unit fails to respond as described, do not use the monitor
until tested and repaired by authorized service personnel.