3
Auto Cutter Jam
If the auto cutter is jammed, use the Line Feed button to try to release the cutter. When you
press the button the printer will try to re-initialize the cutter and retard it in home position.
However if the cutter jam cannot be resolved this way, release it manually until the printer is
able to retard it in home position.
LEDs
“Power” – a green LED. Lights continuously when the printer is powered on.
“Power” – a green LED. Flashes if the printing head has overheated.
“Error” – a red LED. Flashes red when the printer is out of paper, lights red constantly if the
cover is open.
“Error” – a red LED. Flashes about five times a second if there is an auto cutter jam.
Button LF (Line Feed)
Pressing this button feeds the paper until it is released.
The button must be pressed to continue printing after out of paper error.
Pressing the button will try to retard the auto cutter in home position, if the cutter is jammed.
If a manual macro execution is selected the button must be pressed for each macro execution.
Holding down the button while the printer is switched on prints the self-test when the button
is released.
DIP Switches
Sw1
Sw2
Sw3
Baud rate (bps)
OFF
OFF
OFF
1200
ON
OFF
OFF
2400
OFF
ON
OFF
4800
ON
ON
OFF
9600
OFF
OFF
ON
19200
ON
OFF
ON
38400
OFF
ON
ON
57600
ON
ON
ON
115200
OFF
ON
Sw4
Auto cutter disabled
Auto cutter enabled
Sw5
Standard commands
Extended commands
Sw6
Sw7
Sw8
Code page
OFF
OFF
OFF
Uses the flash setting, ESC t enabled
ОFF
OFF
ON
USA CP437
OFF
ON
OFF
Bulgarian CP856
OFF
ON
ON
Russian CP866
ON
OFF
OFF
Latvian
ON
OFF
ON
Lithuanian
ON
ON
OFF
Polish
ON
ON
ON
Uses the flash setting, ESC t disabled
