Datcon DT9102 B, Руководство по эксплуатации

Страница: 32 / 60

DT9102 B
7.6. Synchronisation mode (04. menu item)
Function Setting the remote synchronisation mode.
Sequence of operations 1. Enter the menu by typing the supervisor code.
The way the code should be typed in is described in
Chapter 7.1. Type in the code (password)
. You will see this
on the display:

.
2. Keep stepping by pressing the ▲ button until the menu
item


appears.
3. Enter the menu item by pressing the ENTER button.
4. You will see the actual synchronization mode on the
display. The mnemonic will be blinking.
5. You can change the synchronisation mode by pressing
the ▲ button.
•


= no remote synchronisation [factory setting]
•


= synchronisation of seconds.
•


= synchronisation at the time given in

menu item.
Exit from the menu item 1. After finishing the setting, press the MENU button to exit
the menu item, and you will see this:

.
(2. If you want to change the setting you have just done, or
if you just want to check what you have typed in, go on with
the operation from point 3 of the
Sequence of
operations .)
(3. If you don’t want to exit the menu, as you want to make
further settings, then you may select the desired menu
items by pressing the ▲ button.)
Exit from the menu
1. Press the MENU button. First the mnemonic

( Save ), then the mnemonic

( Exit ) will be shown on
the display. With this the storing of the settings is
completed. The instrument has exited the menu and goes
on with the measurement.
32
20180905-V120180905-V1