Datavideo NVS-30, Инструкция по эксплуатации, Страница: 46 / 59

46
two to control devices one and three. For details on enabling multi-device control in
an NVS-30’s Command Center, and using the control buttons to stream and record,
see “ Command Center Control ” page.
5.3 Disable Stream and Record buttons on the front panel
You can disable the physical Stream and Record buttons on the NVS-30 device to
prevent someone from inadvertently stopping a streaming or recording session. This
option only applies to the NVS-30 you are connected to, and not other NVS-30
devices you may be controlling.
To disable the Stream and Record buttons:
1. In the Command Center, click Control .
2. Select Disable Stream and Record buttons on this NVS-30 device . The Stream and
Record buttons on the NVS-30 device are disabled.
Note: This button disable feature is off by default.
5.4 Enabling multi-device control
This section details how to enable multi-device control of up to four other devices in
the Command Center.
1. In the Command Center, click Control .
2. Select
Control multiple NVS-30 devices
.
3. For each NVS-30 device that you want to control, enter the network IP address of
the device. Click Scan after entering the IP address to verify if the device can be
found on the network. For information on acquiring the NVS-30’s IP address, see
Section 3.2 “ Network connection and IP address ” .
4. Activate or deactivate the control for an NVS-30 device by selecting or clearing the
device’s
Active
box.