Datalogic Touch 90 pro, Руководство по продукции

Страница: 80 / 332

Enter/Exit Programming Mode Label Gone Timeout
70 Touch TD1100
Label Gone Timeout
This feature sets the time after the last label segment is seen before the reader prepares for a new
label. The timeout can be set within a range of 10 milliseconds to 2,550 milliseconds (2.55
seconds) in 10ms increments. Label Gone Timeout does not apply to scan modes that require a
trigger pull for each label that is read. See "
Label Gone Timeout" on page 272 for more detailed
programming instructions.
$CSNLG
Select Label Gone Timeout Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from the
Alphanumeric characters in
Appendix D, Keypad
repre-
senting your desired character(s). End by scanning the ENTER/
EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and not
save the entry string. You can then start again at the begin-
ning.
~
CANCEL
DEFAULT
016 = Timeout of 160 ms