Datalogic Touch 90 pro, Руководство по продукции

Страница: 52 / 332

Enter/Exit Programming Mode Intercharacter Delay
42 Touch TD1100
Intercharacter Delay
This parameter specifies the intercharacter delay between the end of one character and the
beginning of the next. The delay can be set within a range of zero (0) to 990 milliseconds in
10ms increments. A setting of zero specifies no delay.
See "Intercharacter Delay" on page 261
for more detailed programming instructions.
NOTE
This feature applies ONLY to the Keyboard Wedge interface.
$CR21C00 
Intercharacter Delay = No Delay
$CR21C
Select Intercharacter Delay Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix D, Keypad
representing your desired character(s). End by scanning
the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again at
the beginning.
~
CANCEL
DEFAULT
00 = No Intercharacter Delay