Datalogic Matrix 210N, Справочное руководство

Страница: 22 / 167

MATRIX 210N™ REFERENCE MANUAL
10
1
Once Matrix 210N is focused at the correct reading distance, you must configure it for
optimal code reading relative to your application.
Setup
5. Enter the Setup function by pressing and holding
the X-PRESS push button until the Setup LED is
on.
6. Release the button to enter the Setup function.
The Setup LED will blink until the procedure is
completed.
The Setup procedure ends when the Image
Acquisition parameters are successfully saved in
the reader memory, the Setup LED will stop
blinking and Matrix 210N emits 3 high pitched
beeps.
If the calibration cannot be reached after a timeout
of about 5 (five) seconds Matrix 210N will exit
without saving the parameters to memory, the
Setup LED will stop blinking and in this case Matrix
210N emits a long low pitched beep.
Figure 12
– X-PRESS Interface: Setup
Function
Learn
7. Enter the Learn function by pressing and holding
the X-PRESS push button until the Learn LED is
on.
8. Release the button to enter the Learn function.
The Learn LED will blink until the procedure is
completed.
The Learn procedure ends when the Image
Processing and Decoding parameters for
a single
code are successfully saved in the reader memory,
the Green Spot is activated, the Learn LED will stop
blinking and Matrix 210N emits 3 high pitched
beeps
2
.
If the autolearning cannot be reached after a
timeout of about 3 (three) minutes Matrix 210N will
exit without saving the parameters to memory, the
Learn LED will stop blinking and in this case Matrix
210N emits a long low pitched beep.
Figure 13
– X-PRESS Interface: Learn
Function
NOTE:
When using X-PRESS or the BM150 menu to perform the Auto-learn,
only a single code can be configured (successive Learns will substitute the
current code). To configure multiple code symbologies, use the DL.CODE
Auto-learn procedure.
2
The Learn procedure will not recognize the following symbologies: Postal Codes, Pharmacode, MSI, Standard 2 of 5,
Matrix 2 of 5.