Datalogic Gryphon I GFS4400, Руководство по продукции

Страница: 84 / 324

Enter/Exit Programming Mode Reading Parameters
82 Gryphon™ I GFS4400
Serial Start Character
$CSTON
Select Serial Start Characters
To configure this feature scan the ENTER/EXIT PROGRAMMING
MODE barcode above, then the barcode at left, followed by
the digits (in hex) from the Alphanumeric characters in
Appendix E, Keypad
representing your desired charac-
ter(s). End by scanning the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode to abort and not
save the entry string. You can then start again at the begin-
ning.
~
CANCEL
DEFAULT
0x02 = Serial Start Character is [02 STX]
See page 268 in “References” for more information.
Serial Stop Character
$CSTOF
Select Serial Stop Characters
To configure this feature scan the ENTER/EXIT PROGRAMMING
MODE barcode above, then the barcode at left, followed by
the digits (in hex) from the Alphanumeric characters in
Appendix E, Keypad
representing your desired charac-
ter(s). End by scanning the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode to abort and not
save the entry string. You can then start again at the begin-
ning.
~
CANCEL
DEFAULT
0x03 = Serial Stop Character is [03 ETX]
See page 268 in “References” for more information.
The Serial Start/Stop Characters must be different and must not contain
reserved characters (see
Appendix F, Reserved Characters
)