Datalogic AV7000, Руководство по продукции

Страница: 261 / 352

SETTING UP THE DM3610 DIMENSIONER
PRODUCT REFERENCE GUIDE
247
19. Enter this displayed value in the Operating Mode > Far Distance Offset field.
20. Click Update to save your changes.
SETTING UP THE DM3610 DIMENSIONER
DM3610 Dimensioners provide focus data for Datalogic cameras, including the AV7000,
NVS9000, and AV6010.
Refer to the DM3610 Dimensioner Reference Manual (or Two-Head Dimensioner Refer-
ence Manual) for complete information on installation and calibration of the DM3610. It
is available for download from
www.datalogic.com .
Preparation
Before beginning the DM3610 focusing process, a few preliminary settings are required.
1. In the DM3610 e-Genius under Modify Settings , navigate to Serial | Main or Aux
depending on the port wired to the AV7000 (typically Main, consult your applica-
tion interconnect diagrams for details). The Serial | Main window opens.
2. Make sure the selected Baud Rate matches that of the AV7000 (AV7000 uses the
main port, RS485 (RS422), at 115200).
For single Dimensioner applications, the DM3610 must be running software version
1.8.11 or greater. For multi-head applications, the DM3610’s must be running 1.8.1 and
the DC3000 must be version 1.3.60 or greater.
The Dimensioner scan line must be installed at least 500 mm [20 in] upstream from the
nearest camera scan line.
The examples used in this guide use Imperial units i.e. inches. If the system is config-
ured for metric, the unit of measure will be in mm.
Remember to reset these parameters to the application specifications after the calibra-
tion is complete.
When working with a multi-head Dimensioning system, the focus setup steps apply to
the unit designated as the “Tach Master” by the DC3000.