DataDirect Networks S2A9550, Руководство пользователя

Страница: 95 / 118

Trouble Shooting
DataDirect Networks S2A 9550 User Guide
83
4.1 Maintaining the S2A9550
This section provides information regarding error recovery on the S2A9550.
To display the list of all current system and drive enclosure faults, enter command:
FAULTS
4.1.1 Component Failure Recovery
The S2A contains redundant and hot-swappable fans and power supplies. A single component
failure, therefore, will not shut down the system. In the unlikely event of a component failure,
you can replace the failed component while the S2A is running. The replaced component will
automatically be returned to service in the system.
4.1.1.1 Power Supply Failure
A power supply failure message will be displayed on your console if a power supply fails. The
status LED on the power supply module will also turn red
(Figure 4-69)
.
NOTE : The S2A should not be operated with any open slots for more than 15 minutes. Make sure
you have the replacement power supply available before removing the failed module.
1. If installed, remove the cover panel by removing the two thumbscrews.
2. Locate the failed power supply module which is indicated by a red Status LED. Turn off its
power switch.
3. Remove the two thumbscrews. Then slide the module out of the bay.
4. On the new module, check that the power switch is off.
5. Then slide the module into the bay. Make sure it is fully inserted. Install the two
thumbscrews to secure it.
6. Turn on the power switch. Check that the Status LED is green, indicating that the module
is operating normally.
7. Replace the cover panel if previously removed.
Figure 4-69 Power Supply/Cooling Modules in the Front of S2A
Thumbscrew
Status LED Thumbscrew