![background image](http://html1.mh-extra.com/html/datacard/rp90/rp90_user-manual_3645213043.webp)
Using the LCD menus
RP90 Plus E and RL90 User Guide
37
Ink
Ink Type
YMCK: 0
YMCKPO: 2
YMCKK: 4
Displays the type of ink ribbon that is loaded in the printer.
Datacard supports YMCK and YMCKK ink ribbons. (The printer
detects the type of ink ribbon; it cannot be set.) See your dealer
regarding support for YMCKPO ink ribbon.
Black level
Choose from seven gradations from -3 (lighter) to +5 (darker).
Black mode
Choose Standard or Fine. Change to Fine if thin lines or small
black text is blurred (printing speed is slower).
SP - Ink1 Level
Use SP - Ink1 and Ink2 levels to set the darkness level of
special inks that will be available in the future.
SP - Ink2 Level
See SP -Ink1 Level above.
Retransfer
Media type:
750
1000
Datacard retransfer ribbon is available in 1000 frames per roll.
Temp Level
Set the retransfer roller temperature. Set from -3 (lower) to +2
(higher).
Speed (front)
Set the retransfer speed for the front of the card. Set from -10
(slower) to +2 (faster). Initialize the retransfer film after making
changes. See
“Initialize the retransfer film” on page 17
.
Speed (back)
Set the retransfer speed for the back of the card. Set from -10
(slower) to +2 (faster). Initialize the retransfer film after making
changes. See
“Initialize the retransfer film” on page 17
.
MG Print (JIS)
Select ON or OFF.
Standby
Front Wait
Back Wait
When printing both sides of a card and using an optional
smart card (IC) unit, specifies whether to wait after the front
side or the back side of the card.
Buzzer
ON or OFF
Use to turn the electronic beep sound ON or OFF. The sound
can indicate an error, when fewer than 20 cards remain in the
card hopper, or to confirm a menu selection.
Power Saving
OFF or up to 60 minutes
The printer enters power save mode after a specified period
of inactivity. Choose from OFF or select from 5 to 60 minutes
in 5 to15 minute increments. “Sleeping” appears on the LCD
display. To cancel power save mode, press RESET and then
the ENTER key. The printer uses one set of supplies.
Bend Remedy
Temp Level
Choose from -5 (lower) to 0 (higher) or OFF to set the bend
remedy roller temperature. See
“Bend remedy” on page 56
for more information.
Speed
Choose from -2 (slower) to +2 (faster) to set the bend remedy
speed. See
“Bend remedy” on page 56
for more
information.
Cooling time
Set the cooling time from 0 (None) to 15 seconds.
Menu Display
Settings
Function
Содержание RP90
