cleaning & Maintenance
Before the Bread Maker is packed away for storage, ensure that it has completely cooled down,
is clean and dry, and put the Kneading Blade in the drawer, and close the Lid.
BAKING PAN
Remove the Baking Pan by turning it counter-clockwise, then pulling the
handle to remove it. Wipe inside and outside of Baking Pan with a damp
cloth, do not use any sharp or abrasive agents, as these will damage the
Baking Pan’s non-stick coating. The pan must be dried completely
before re-installing. Baking Pan is also dishwasher safe.
KNEADING BLADE
If the Kneading Blade is difficult to remove from the axle, fill the Baking Pan
with warm water and allow it to soak for approx. 30 minutes. The Kneading
Blade can then be more easily removed.
To clean the Kneading Blade, wipe it down carefully with a damp cotton
cloth. Both the Baking Pan and the Kneading Blade are dishwasher safe.
Gently wipe the outer surface of the Bread Maker with a damp cloth.
Do not use any abrasive cleaners as this will damage the surface.
Never immerse the Bread Maker in water for cleaning.
Before storing the Bread Maker, ensure that it is completely cooled and dry.
Put the Kneading Blade in the Baking Pan for storage and close the Lid.
LID AND WINDOW
Clean the Lid inside and outside with a slightly damp cloth.
HOUSING
Gently wipe the outer surface of housing with a wet cloth. Do not use any
abrasive cleaner to clean as this would degrade the high polish of the
surface. Never immerse the housing into water for cleaning.
Disconnect the machine from the power and let it cool down prior to cleaning.
∙ 28 ∙
PROBLEM
CAUSE
SOLUTION
Smoke comes out of the baking
chamber or the vents.
The ingredients have stuck to
the baking chamber or on the
outside of the Baking Pan.
Unplug the Bread Maker and
clean the baking compartment
or the outside of the Baking Pan.
The bread goes down in the
middle after baking and is
moist on the bottom.
The bread was left in the pan for
too long after baking.
Take bread out of the Baking
Pan before the warming
function has run the full time.
It is difficult to remove bread
from the Baking Pan.
The bottom of the loaf is stuck
to the Kneading Blade.
Clean the Kneading Blade and
shaft after baking. If necessary,
remove the Baking Pan from the
Bread Maker and fill the Baking
Pan with warm water and let sit
for 30 minutes.
The ingredients are not
mixed or the bread is not
baked correctly.
Incorrect program setting.
The Start/Stop Button was
touched while baking.
The rotation of the Kneading
Blade was blocked.
Check selected menu and
other settings.
Do not use the ingredients
and start over again.
Check that the Kneading Blade
is not blocked by removing it.
Remove the Baking Pan
and make sure that the
drivers turn. If not, contact
Customer Service.
The appliance does not start.
The Display shows HHH.
The Bread Maker was used too
recently.
Unplug the Bread Maker,
remove the Baking Pan, and let
both cool. Then try again.
Troubleshooting
∙ 29 ∙
