17
INTEGRAL-M88 Manual
INTEGRAL
Configuration of Dante digital audio
Routing digital audio channels with DANTE Controller
1
Open DANTE Controller
2
The program will automatically discover all the units present in
the network and will locate them on the main screen; If this is the
first time you have connected them to the network, the names of
the devices in DANTE could be like the ones shown below:
Note: If any device that should appear on the network is not
detected by DANTE Controller, these could be the causes:
·
The unit has no power or has not been turned on.
·
The CAT5e or higher cable is defective or poorly connected.
·
The unit is on a different subnet from the others.
·
The unit is not able to synchronize with the other devices on
the network.
However, if the case of no connection was due to either of the
last two reasons, the unit should appear at least in the “device
Info” or “clock status” tabs. A quick solution to the problem is to
power cycle the unit and reestablish the connection to the eth-
ernet switch.
Содержание 10721170
Страница 1: ...INTEGRAL M88 Users manual www dasaudio com ...
Страница 45: ......
