44 / 47
5. Maintenance and Common Troubleshooting
When you use the product, if it does not work properly, please do not rush to determine
that the product is faulty, please refer to the table
《
Common Troubleshooting Table
》
to find
the cause of the fault. At the same time, pay attention to check whether it is caused by the
external environment, such as temperature, humidity does not meet the requirements or
load overload
5.1 Daily maintenance
1. The system starts from the factory and needs to charge the system once every 6
months.
2. During system storage, the system should be checked regularly by professionals to
check whether the line is loose or falling off, or to clean the surface and interior of the system;
if any defects are found, please contact the dealer in time.
5.2 Common troubleshooting table
：
Fault phenomenon
Reason
Solution
No response by switch
Internal failure
Please contact the supplier
Button start wire is
damaged or poorly
installed
Check the button start wire and installation
situation
Short battery discharge time
Low battery
Keep the product charged for more than 4 hours
to fully charge the battery
Product overload
Check load status and remove non-critical
products
Battery aging,
capacity decline
To replace the battery, please contact the
supplier to get the battery and its components
Unable to charge and
discharge
Internal failure
Please contact the supplier
Battery over
temperature
Allow to stand at room temperature for more
than 3 hours
