Darfon B09ULF, Руководство по установке

Страница: 22 / 28

I N S T A L L A T I O N M A N U A L B 0 9 U L F L I T H I U M B A T T E R Y
R e v . 1 © 2 0 1 9 D a r f o n E l e c t r o n i c s C o r p . P a g e 2 2 o f 2 8
7 OPERATIONS
7.1 Power On or Off
Before powering on, please:
 Make sure the system wiring is correct.
 Make sure the terminals are securely fastened.
 Ensure that the parameters of the external access device match
the system.
To power on, press the switch button, the battery box indicator
lights up, and the system is turned on. To power off, press the
switch button in the running state, the button pops up, the battery
module indicator goes out, and the system is shut down.
 It is recommended to turn off the device when not used for a
long time.
7.2 Display state
The battery has 6 LED lights to indicate protection, operation, power, and function.
Legend
：
light stays on light flashing at 1 Hz
Mode Status Capacity LED (Low to high) ALM RUN
Shutdown
Charging SOC 0%-25%
SOC 26%-50%
SOC 51%-75%
SOC 76%-99%
SOC 100% (Charge cutoff)
Discharging SOC 1%--25%
SOC 26%--50%
SOC 51%--75%
SOC 76%--100%
SOC 3%
Protection Low-voltage protect (cell or module)
Overvoltage protect (cell or module)
Overcurrent (charging)
Overcurrent (discharging)
Low-temp. protect (Charging)
High-temp. protect (Charging)
Low-temp. protect (Discharging)
High-temp. protect (Discharging)
High-temp. protect (MOSFET)
Short circuit protect (Charging)
Short circuit protect (Discharging)
Errors &
Dysfunctions MOSFET Charging error
MOSFET discharging error
Voltage front end sampling error
Voltage front end disconnect
Temp. front end sampling error
Temp. front end disconnection
Current front end sampling error
Cells seriously imbalanced
Parameter configuration error
Equipment parallel error
Other Errors /