6
Backside
Fig. 2
37)
Channel 2 GND
47)
Channel 3 Line 4 RCA Input
38)
Channel 1 GND
48)
Channel 3 Line 3 RCA Input
39)
AC Inlet
49)
Channel 2 Line 2 RCA Input
40)
Master XLR Balanced Out
50)
Channel 2 Aux 2/Phono 2 RCA Input
41)
Output Trim Control
51)
Channel 2 Aux 2/Phono 2 Selector
42)
Player Control B
52)
Channel 1 Line 1 RCA Input
43)
Player Control A
53)
Channel 1 Aux 1/Phono 1 RCA Input
44)
Master RCA Unbalanced Out
54)
Channel 1 Aux 1/Phono 1 Selector
45)
Zone RCA Out
55)
Mic Trim Control
46)
Rec Out
56)
Mic 2 Jack Unbalanced Input
Installation
Remove all packing materials from the DS-CM-10. Check that all foam and plastic padding is removed.
Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Functions
1/ 2/ 3. Mic Channel EQ Treble/ Mid / Bass
The mic channel is fitted with 3-band EQ. The Treble (
3
) and Bass (
7
)
shelving controls have their frequencies fixed at 13 Khz and 70 Hz
respectively. The Mid range control (
1
) has a center frequency of
1 kHz. The Bass and Mid bands have up to 23 dB cut and 12 dB boost,
the High band has up to 14dB cut and up to 12dB boost all three bands
have a centre detent for “OFF”. Turning the Equalizer level control to the
right amplifies the frequency range, turning to the left attenuates the
signal. Minor changes to the Equalizer control usually produce the best
results. Try to avoid excessive enhancement of the MID band.
4. Talkover Switch
This switch has two modes:
.
A. On
: With the switch in this position, the Microhone channel is
activated and is mixed with channel 1-3.
B.
Off
: In this position the Microphone channel is deactivated.
C. -14dB
: In this position the Microphone channel is activated and
The levels of channels 1-3 are attenuated by 14dB.
Fig. 3
Содержание DS-CM-10
Страница 1: ...DS CM 10 ORDERCODE D2183...
Страница 17: ...2009 DapAudio...
