DAPAudio D3207 Entertainer mobile set pro, Руководство по эксплуатации продукта

Страница: 11 / 31

9
20. DSP Selection Knob
Use this dial for selecting an effect preset. Pushing the dial activates the selected preset.
21. Eff Level Control
Rotating the knob clockwise increases the input level and counter clock wise decreases the input level.
When the
Peak (23) LED lights, decrease the input level. Don’t forget to adjust the DSP output level
appropriately.
22. Mix to main
Rotating the knob clockwise increases the DSP output level and counterclockwise decreases the DSP
output level.
23. Peak/Signal LED Indicators
The green LED lights when there is any input signal, the red LED lights when the signal strength reaches the
peak level. This LED lights continually if the DSP section is bypassed. If the DSP section is active, The LED
works as a peak LED. So if the LED lights, decrease the input level of the DSP section by using the
Eff Level
(22) control.
Patch panel
24. Mic Input Jack
XLR balanced low impedance microphone input.
25. Mono Line Input Jack
1/4” balanced input jack is suitable for devices with line outputs like keyboards, drums, outboard effects,
etc. Accepts both balanced and unbalanced cables.
26/ 27/ 28/ 29. Stereo Line Input
1 / 4”, 1/8” TRS jacks or RCA jacks for line level devices such as tape recorders, CD players or other stereo
equipment.
30. REC Out
The REC out provides a mix output which is independent of the Master Level (13) control. Connect a
device, such as a cassette or DAT recorder. All adjustments to the input level, channels EQ, and DSP can
be heard through the REC output. You can only adjust the record level using input controls on your
recording equipment.
31/32. Amplifier Send / Return Jacks
Each channel of the amplifier has a send and return jack. These jacks offer an insertion point. The (stereo)
effect loop is situated between mixer and poweramp (before EQ and master section).
33. AUX Return
Use this output in combination with the Aux Send (39) to connect an external effect device. Using an
external effect device in your aux effect loop will run this effect in parallel with the internal effects.
34. Speaker Output
Connect the Entertainer Mobile Set Pro speakers using the supplied speakon cables.
35. Power Switch
Do not supply power before the whole system is set up and connected properly.