Dantherm DanX 2/4 XKS, Инструкция по установке, пусконаладке и обслуживанию

Страница: 10 / 39

3. INSTALLATION
8
3.2 Installation of modules
Before placing the single modules in the right order, accordingly to chapter 3.1 the wooden
crossbeams or pallets have to be removed and the separate delivered feet mounted on the
base frame. To do so the following has to be done:
•
Unwrap the module, open the inspection door and take out the separate box with the
feet and the assembly rails for the unit.
•
On the fan modules remove the transport brackets (1) which are holding the fan
(spring vibration dampers only) as it is easier now then after the unit has been
assembled (see drawing).
•
Check the rubber gaskets (2) at the end of each module that they are not damaged or
loose. This is important, as it is impossible to replace the gaskets after the modules
have been assembled!
•
Lift the unit with a fork lift or pallet lift and unscrew the wooden cross beams.
•
Screw the feet on the base frame (see drawing) and place the modules as close as
possible together where they should be installed. When the feet are mounted it is only
possible to move the modules a few millimetres, otherwise the feet can bend or break.
If you have to move the modules more, then use a fork lift or pallet lift.
1
2