DMR-6 Mid-Rise Scissor Lift
27
P/N 5900253 — Rev. A — August 2020
Maintenance
⚠
DANGER
Before performing maintenance on your Lift, make sure it is disconnected from
power. The Lift uses electrical energy; if your organization has Lockout/Tagout
policies, make sure to implement them before performing any maintenance. If you
come into contact with high voltage/current, you could be injured or killed.
To maintain your Lift
:
•
Daily
: Keep the Lift clean. Wipe up any oil spills, clean any dirt.
•
Daily
: Make a visual inspection of all moving parts and check for damage or excessive wear. If
you find any damaged or worn parts, take the Lift out of service until they are replaced.
•
Daily
: Make sure the Safety Locks are in good operating condition. If you find that the Safety
Locks are damaged or excessively worn, take the Lift out of service until they are replaced.
Do
not use your Lift if the Safety Locks are damaged or excessively worn
.
•
Weekly
: Check all controls to make sure they are functioning normally.
•
Weekly
: Check all labels on the unit. Replace them if they are illegible or missing.
•
Monthly
: Lubricate the grease fittings. We recommend using white lithium grease or similar.
•
Monthly
: Check the Power Unit’s Hydraulic Fluid levels. Refill if low.
⚠
WARNING:
Do not operate your Lift if you find issues; instead, take it out of service, then
contact your dealer, email
, visit
dannmar.com/support
, or call
(877) 432-6627.
Troubleshooting
This section describes how to troubleshoot your Lift.
Note
: If your Lift is not functioning correctly, you must take it out of service until it is fixed. All repair
work
must
be done by qualified personnel.
⚠
WARNING
The Lift uses electrical energy; if your organization has Lockout/Tagout policies,
make sure to implement them before performing any Troubleshooting.
Issue
Action to Take
Platform moves erratically
or squeaks when in use.
Move the Platform up and down a few times, with a break between
each; there could be residual air in the Hydraulic System.
Platform does not go up or
down.
Make sure the Power Unit is connected to an appropriate power
source.
Make sure none of the Hydraulic Hoses are pinched or leaking.
Make sure there is sufficient Hydraulic Fluid in the reservoir on the
Power Unit.
Hydraulic Fluid is old or
dirty.
Replace the dirty fluid with clean, approved Hydraulic Fluids, such as
Dexron III, Dexron VI, Mercon V, Mercon LV, Shell Tellus S4 / S3 /
S2, or comparable.
Содержание DMR-6
