Dannmar D2-10 Series, Инструкция по установке и эксплуатации

Страница: 58 / 88

D2-10 Series Two-Post Lifts
58
P/N 5900249 — Rev. B — February 2021
Lubricating the Lift
D2-10 Series Lifts work better and longer if you keep them lubricated.
Lubricate the following with a white lithium grease:
Both Safety Cable Axle pins and Cable Sheaves.
All 6 Cable Sheaves
Sides of the Lift Post where the Slide Blocks make contact
Cable sheave pins (lubricate with WD-40 or equal)
Perform an Operational Test
Before putting your Lift into normal operation, we recommend raising and lowering it several times with
a typical Vehicle on the Lift. This will help you get a feel for how to operate the controls and help get
any residual air out of the Hydraulic System (sometimes called “bleeding” the system).
⚠
DANGER
Automotive Lifts are dangerous tools when used by inexperienced or impaired
technicians. When you even hear the words “Automotive Lift,” your brain should
automatically register the fact that lifting a vehicle is a serious endeavor with life-
threatening risks if mandatory lifting precautions are ignored.
During the Operational Test, check for proper installation and operation. Do not raise any additional
Vehicles until a thorough Operational Test has been done with a typical Vehicle.
⚠
WARNING Never raise a Vehicle whose weight exceeds the rated capacity of the Lift. Do not
leave the controls until the Lift is engaged on its Safety Locks. Only trained
personnel should raise or lower the Lift.
To perform an Operational Test :
1. Follow the instructions in
Raising a Vehicle
and
Lowering a Vehicle
to safely raise and lower
a Vehicle on the Lift.
⚠
WARNING Be sure to follow the instructions carefully when it comes to contacting the
manufacturer’s recommended Lifting Points on the underside of the Vehicle. If you
do not, the Vehicle could become unstable and fall, which could damage the
Vehicle, damage the Lift, and injure or even kill anyone under the Vehicle.
2. Verify the Hydraulic Power Unit reservoir is full, double check that all Wire Rope, Wiring and
Hydraulic Hoses are properly positioned within sheaves and clips and that all sheave retaining pins
and or clips are secure.
3. Adjust the Lift Arms under the Vehicle so the Adapters are
directly under
the Lifting Points for
the Vehicle you are raising.
If necessary, use the included Auxiliary Adapters for extra height.
4. Raise the Lift until just before the Adapters make contact with the Lifting Points.
5. Check the Arm Restraint Gears on all four Lift Arms to make sure they are engaged.
If they are not engaged, move the Lift Arms back and forth until they engage.
6. Raise the Lift until the tires of the Vehicle are a few inches off the ground.
7. Check to make sure all four Adapters are making solid contact with the Lifting Points.